Buod:Sa pagmimina, ang Raymond Mill ay isang napakahalagang kagamitan sa pagpoproseso ng bato. Depende sa laki ng produksiyon, mayroong pagkakaiba sa paggamit.

Sa pagmimina, ang Raymond Mill ay isang napakahalagang kagamitan sa pagpoproseso ng bato. Depende sa laki ng produksiyon, may pagkakaiba sa paggamit ng malalaking linya ng produksiyon at ng maliit na kagamitan na Raymond mill. Mahalaga ang pag-install at pag-debug ng kagamitan sa Raymond mill sa proseso ng pagpoproseso ng ating mga materyales sa minahan. Dito, ipinapaliwanag ni Xiao Bian ang mga dapat tandaan sa pag-install at pag-debug ng maliit na Raymond mills.
Una sa lahat, dapat i-install ng mga propesyonal na technician ang bagong-install na maliit na Raymond mill nang tama.
Secondly, in the commissioning operation stage of the installed small Raymond mill, it should be divided into two stages: no-load operation and load operation. In the small Raymond grinding load operation test machine, the Raymond mill's grinding roller device should be fastened with the wire rope to prevent the grinding roller ring ring contact impact with the operation of the small Raymond mill. At the same time, it should be noted that the empty running test machine should not be less than 1 hour, and ensure that the main engine is running smoothly and orderly, so that the oil temperature in the tank is kept below 80 °C, and the temperature rise should not exceed 40 °C.
Pangatlo, kapag nagtatrabaho tayo sa operasyon ng maliit na Raymond mill load, dapat nating bigyang pansin ang penomena ng abnormal na ingay at abnormal na panginginig pagkatapos gumana nang normal ang gilingan, upang matiyak na walang pagtagas ng hangin sa mga magkasanib na bahagi ng bawat tubo. Kapag natapos na ang pagsubok ng makina, higpitan muli ang bawat tornilyo.
Fourth, when we are debugging the operation of the small Raymond mill, we must pay attention to the air blower to start the air load, and then load it after the equipment is running normally. At the same time, observe the smoothness of its operation. Under the condition of ensuring no abnormal sound and vibration, the maximum temperature of the rolling bearing is not higher than 70 °C, and the temperature rise is not more than 35 °C.
Fifth, in the installation and commissioning of the small Raymond mill, the lower the working height of the pressure spring, the stronger the rolling capacity of the low roller of the grinding roller, and the higher the output of the equipment. Therefore, in the process of using small Raymond mills, we must pay attention to controlling the working height of the pressure springs, generally between 200-210 mm.