?锄别迟：Maden i?letmecili?inde, Raymond de?irmeni ?ok ?nemli bir ta? i?leme ekipman?d?r. ?retim büyüklü?üne ba?l? olarak kullan?mda farkl?l?klar vard?r.

Maden i?letmecili?inde, Raymond de?irmeni ?ok ?nemli bir ta? i?leme ekipman?d?r. ?retim boyutuna ba?l? olarak, büyük üretim hatlar? ile kü?ük Raymond de?irmen ekipmanlar?n?n kullan?m? aras?nda fark vard?r. Maden malzemelerimizi i?leme sürecinde, Raymond de?irmen ekipman?n?n kurulumu ve ayar? ?ok ?nemlidir. Burada, Xiao Bian kü?ük Raymond de?irmenlerinin kurulumu ve ayar? s?ras?nda dikkat edilmesi gereken noktalar? k?saca ?zetliyor.
?ncelikle, yeni kurulmu? kü?ük Raymond de?irmeninin do?ru bir ?ekilde kurulmas? i?in profesyonel teknisyenlere ba?vurmal?y?z, b?ylece
Secondly, in the commissioning operation stage of the installed small Raymond mill, it should be divided into two stages: no-load operation and load operation. In the small Raymond grinding load operation test machine, the Raymond mill's grinding roller device should be fastened with the wire rope to prevent the grinding roller ring ring contact impact with the operation of the small Raymond mill. At the same time, it should be noted that the empty running test machine should not be less than 1 hour, and ensure that the main engine is running smoothly and orderly, so that the oil temperature in the tank is kept below 80 °C, and the temperature rise should not exceed 40 °C.
??üncüsü, kü?ük Raymond de?irmen yükünün ?al??mas?yla ilgili ?al???rken, de?irmen normal bir ?ekilde ?al??maya ba?lad?ktan sonra ses anormalli?i ve titre?im anormalli?i fenomenlerine dikkat etmeliyiz, b?ylece her boru hatt? ba?lant?s?nda hava s?z?nt?s?n?n olmad???ndan emin olmal?y?z. Test makinesi bitti?inde, her viday? tekrar s?k?n.
Fourth, when we are debugging the operation of the small Raymond mill, we must pay attention to the air blower to start the air load, and then load it after the equipment is running normally. At the same time, observe the smoothness of its operation. Under the condition of ensuring no abnormal sound and vibration, the maximum temperature of the rolling bearing is not higher than 70 °C, and the temperature rise is not more than 35 °C.
Fifth, in the installation and commissioning of the small Raymond mill, the lower the working height of the pressure spring, the stronger the rolling capacity of the low roller of the grinding roller, and the higher the output of the equipment. Therefore, in the process of using small Raymond mills, we must pay attention to controlling the working height of the pressure springs, generally between 200-210 mm.