Sammanfattning: In gruvutveckling ?r Raymond-kvarn mycket viktig stenbearbetningsutrustning. Beroende p? produktionsstorlek finns det skillnader i anv?ndningen

Inom gruvutveckling ?r Raymond-kvarn en mycket viktig stenbearbetningsmaskin. Beroende p? produktionsvolymen finns det skillnader i anv?ndningen av stora produktionslinjer och sm? Raymond-kvarnar. Vid bearbetning av v?ra malmer ?r det mycket viktigt att installera och fels?ka Raymond-kvarnutrustningen. H?r sammanfattar Xiao Bian kort de punkter som beh?ver uppm?rksammas.
F?rst och fr?mst m?ste vi l?ta de professionella teknikerna installera den nyinstallerade sm? Raymond-malen korrekt, f?r att undvika skador p? komponenter under installationsfasen eller problem med felaktig installation som kan p?verka den efterf?ljande malningsproduktionen.
Secondly, in the commissioning operation stage of the installed small Raymond mill, it should be divided into two stages: no-load operation and load operation. In the small Raymond grinding load operation test machine, the Raymond mill's grinding roller device should be fastened with the wire rope to prevent the grinding roller ring ring contact impact with the operation of the small Raymond mill. At the same time, it should be noted that the empty running test machine should not be less than 1 hour, and ensure that the main engine is running smoothly and orderly, so that the oil temperature in the tank is kept below 80 °C, and the temperature rise should not exceed 40 °C.
F?r det tredje, n?r vi arbetar med sm? Raymond-kvarnens drift, b?r vi vara uppm?rksamma p? fenomenet onormalt ljud och onormal vibration efter att kvarnen har fungerat normalt, f?r att s?kerst?lla att det inte finns n?gra l?ckage i fogarna p? varje r?rledning. N?r provmaskinen ?r klar, dra ?t varje f?stdetalj igen.
Fourth, when we are debugging the operation of the small Raymond mill, we must pay attention to the air blower to start the air load, and then load it after the equipment is running normally. At the same time, observe the smoothness of its operation. Under the condition of ensuring no abnormal sound and vibration, the maximum temperature of the rolling bearing is not higher than 70 °C, and the temperature rise is not more than 35 °C.
Fifth, in the installation and commissioning of the small Raymond mill, the lower the working height of the pressure spring, the stronger the rolling capacity of the low roller of the grinding roller, and the higher the output of the equipment. Therefore, in the process of using small Raymond mills, we must pay attention to controlling the working height of the pressure springs, generally between 200-210 mm.